Gear – Use gear mode to view and manage gear (assets) and provision operating systems and firmware.
MAC COMMAND LINE LIST HOST DRIVER
Use the man command to display the man page for each mode.Ĭertificates – Use certificates mode to view and manage trusted certificates.Ĭollisions – Use collisions mode to detect collisions of host IDs or MAC addresses used by logical domains.Ĭontrollers – Use controllers mode to migrate assets from one Proxy Controller to another Proxy Controller.Ĭredentials – Use credentials mode to view and manage driver credentials.ĭeploy-Setup – Use deploy-setup mode to set up the plan and target to deploy an asset.ĭeploy – Use deploy mode to deploy an asset.ĭiscover – Use discovery mode to discover gear (assets).įWImage – Use fwimage mode to create, view, and manage firmware images.įWProfile – Use fwprofile mode to create, view, and manage firmware profiles. The commands in this section start a mode that includes a set of subcommands. Use the -n| -maxwait to specify a timeout, a maximum number of seconds to wait for a job to complete. Use the -a| -all option to wait for all jobs. Use the -r| -runid option to specify a job runID. Use the -i| -jobid option to specify a job ID. To wait for a job to complete, enter wait in the command prompt. This command can be used from within any mode at any time or from the main command line.
For more information about command scripts, see Command Scripts. The wait command is used in command scripts where many commands are run almost at the same time, and a command must wait to be executed until the job launched by the previous command is completed. You can identify a job by its jobID or by its runID. This can be useful if one job, such as a discovery, is a requirement for another job, such as grouping or managing discovered assets. You can set the CLI to wait until either the most recent job or a specific job finishes before launching a new job, using the wait command.